Guidelines of injection molded components
Submitted by Bhaskar Sinha on Thu, 10/22/2009 - 8:41am
I am looking for any standards / specifications for determining geometrical parameters in product design like minimum / maximum wall thickness, draft angle, rib width/height, boss height & diameter, surface finish, tolerances, etc. based on the material. Any pointers / help in this regard would be highly appreciated.
Comments
Design guidelines for specific material grades.
Since the physical properties of various material types vary considerably, there are no general guidelines, except those very broad ones that apply to all molded products. You should seek out the technical design guidelines for the specific grade of material you are considering from the material supplier.