Injection Molding Titles Include:

Optimizing the Molding Process — Chapter from Plastics Technician's TOOLBOX, by Jerry Golmanavich, Golmanavich Enterprises

Shear Induced Imbalances and MeltFlipper® Technology, by John P. Beaumont, Penn State Erie & Beaumont Technologies, Inc.

The Warpage Simulation with In-mold Constraint Effect in Injection Molding, by Dr. Venny Yang, CoreTech System Co., Ltd.

The Investigation of Flow Behavior of Polymeric Melts in Water Assisted Injection Molding, by Dr. Chao-Tsai Huang, CoreTech System Co., Ltd.

Injection Molding of Woodfiber Plastics Composites, by Michael Burgoyne

State of the Art of Electric injection Molding, by M. Barr Klaus, Electric Injection Services, Inc.

Mold Ejector Pin Melt Flow Volume Sensor, by Fred Buja, FjB PlasTechnology

Water up to 400°F – The Best Way To Heat up Your Mold, by Anna Birkhofer, consultant

Asia Tooling and Molding: How To Be Successful, D.B. "Dusty" Rhodes, Waypoint Bellwether, Inc.

It Is as Easy To Be an Injection Molding Compounder as It Is To Be an Injection Molder, by Peter Lipp, Krauss-Maffei Corporation

Effect of Injection Molding Process Parameters on the Morphology and Quality of Microcellular Foams, by Jingyi Xu

Microcellular Injection Molding of Polylactide-Montmorillonite Nanocomposites, by Sarah Gong, Assistant Professor, University of Wisconsin-Milwaukee

SPE’s e-Learning Center offers you convenient ways to gain practical technical and business knowledge about the plastics industry, knowledge you can use to improve your performance on the job and to increase your value to your employer.