SEMINAR: HOW TO OPTIMIZE YOUR MOLD COOLING TO DRIVE DOWN COSTS AND DRIVE-UP PART PERFORMANCE
The seminar is being offered at two locations and is free of charge.
Wednesday, September 12th, 2018
Waukesha County Technical College — Waukesha, Wisconsin
9:00AM–12:20PM: Presentation
12:30PM–1:30PM: Tour of WCTC Plastics Facility
Waukesha County Technical College — Waukesha, Wisconsin
9:00AM–12:20PM: Presentation
12:30PM–1:30PM: Tour of WCTC Plastics Facility
| How your Cooling Line Layout and Mold Design Are Influencing your Part Costs and Performance Erik Foltz, The Madison Group |  |
| Why You Should Consider High Temperature Water Cooling Units Dan Luke, Norstech |  |
| The Effect of Glass Fiber Length on the Short-term and Long-Term Behavior of Polypropylene Dayton Ramirez, The Madison Group | |
Tuesday, September 18th, 2018
University of Wisconsin—Stout — Menomonie, Wisconsin
9:00AM–12:20PM: Presentation
12:30PM–1:30P: Tour of WCTC Plastics Facility
University of Wisconsin—Stout — Menomonie, Wisconsin
9:00AM–12:20PM: Presentation
12:30PM–1:30P: Tour of WCTC Plastics Facility
| How your Cooling Line Layout and Mold Design Are Influencing your Part Costs and Performance Erik Foltz, The Madison Group | |
| Why You Should Consider High Temperature Water Cooling Units Dan Luke, Norstech | |
| Going Beyond Single Point Measurement: Practical Uses of IR Cameras and DMA Data to Optimize and Troubleshoot Your Mold Sean Mertes, AMCO Polymers |  |
For more information, please go to our website.
To register for each seminar, please email Events@madisongroup.com.
Attendees will have a better understanding of the role of injection molding on the performance of plastic parts and how to optimize part performance.
Educational Outreach Sponsored by:
SPE: Inspiring Plastics Professionals
University of Winsconsin—Stout
Waukesha County Technical College
The Madison Group
Norstech
AMCO Polymers
.jpg)
.jpg)
.jpg)
.jpg)
